Categories

Composite Corrosion Resistance Test Chamber

Model: PW-CCT960
The salt spray test chamber produced by our company is used to test the corrosion resistance of the products after the surfaces of various materials have been subjected to corrosion treatment such as electroplating, anodizing, spraying, and anti-rust oil;
Description SPECIFICATION
The salt spray test chamber produced by our company is used to test the corrosion resistance of the products after the surfaces of various materials have been subjected to corrosion treatment such as electroplating, anodizing, spraying, and anti-rust oil; in order to analyze the samples under specific environmental conditions and evaluation.
Model PW-CCT960
Internal size 160x100x60(WxDxH)cm
External size 265X145X172 (WxDxH) cm
without temperature and humidity host (W125*D60*H110)
Power supply AC3ø   380V  30A  50HZ
Test box interior The PP is integrally formed, the thickness is 10mm, and the temperature resistance of the material can reach -10~90ºC, so that our equipment will not be deformed for a long time using CASS, ACSS and NSS tests.
Thermostatic case GRP and PP gray temperature-resistant and impact-resistant board are used, and PP board mainly plays the role of protection and beautification.
Chamber upper cover It adopts PP one-piece molding, the thickness is 10mm, and the temperature resistance of the material can reach -10~90ºC, so that our equipment will not be deformed for a long time in the CASS, ACSS, NSS test (automatic opening and closing).
Test refill drum Using PP white board, the capacity is 100L.
Test chamber basket frame Using GRP temperature-resistant angle material, the angle can be 20°±5° from the product test angle, and the test bracket can be customized.
Saturated air drum Made of SUS#304 stainless steel plate, thickness 2mm, with automatic water level controller to avoid the inconvenience of manual water addition.
Salt spray test method (1) Laboratory: 35ºC±2ºC
(2) Saturated air barrel: 47ºC±2ºC
Corrosion resistance test method (1) Laboratory: 50ºC±2ºC
(2) Saturated air barrel: 63ºC±2ºC
Temperature and humidity drying test Laboratory temperature: 40ºC~60ºC±1
Humidity: 30±5%RH and natural humidity drying, damp heat control system: internal installation of humidifier, dehumidifier, heater, circulating fan, drainage device, water supply device, water level controller, over-temperature protector, humidification pipe anti-drying The device, circulating air duct, damper, etc. use a circulating fan for strong air supply and circulation, built-in air space, stainless steel circulating fan, through the damper and diffuser, the air is blown out from the air duct evenly, and the temperature and humidity in the mixing room are adjusted well. Distributed to the test space, so as to achieve the purpose of uniform temperature and humidity control.
Damp heat test GB2423.3-93 "Basic Environmental Test Procedures for Electrical and Electronic Products" Test Ca: constant damp heat test method. (Here is just a test that meets the specified temperature and humidity)
a. Test temperature: 23~50ºC±2ºC.
b. Test humidity: 45%~98%±2%RH
PW INSTRUMENTS (GUANGDONG) CO.,LTD    POWERED BY UEESHOP