R&D Air-cooled Thermal Shock Test Chamber

Introduction:

PW-CTS2-19-55A R & D two-box air-cooled thermal shock test chamber is launched for the materials research and development sector 19L small cold and thermal shock test chamber, self-research temperature balance technology, different from the traditional use of high-power refrigeration against high-power heating freezing balance technology.
Take the on-off refrigeration energy regulation technology - central controller according to the different temperature points to control the size of the cooling capacity to achieve temperature static balance, while allowing the operation of equipment is always in a relatively low-power state, energy saving and environmental protection.

Performance: (air-cooled, refers to the room temperature at +25 ℃, no load)    

1. High temperature tank impact range: +40 ℃ ~ +150 ℃   
2. Low temperature tank impact range: -10 ℃ ~ -55 ℃ 
3.Temperature uniformity: ≤±2℃
4. Temperature fluctuation: ≤ ± 0.5℃.
5. High and low temperature shock constant temperature time: 5 min
6. Basket transfer time: within 5 seconds
(Temperature performance test is measured according to the relevant provisions of IEC60068-3 standard; the sensor is placed at the unit air outlet)

1. Studio size: W325 × H240 × D240 mm (internal box size can be customized)      
2. External dimensions: approx. W750 × H1810 × D1120mm
3. Box structure: with independent product testing area, high temperature heat storage area, low temperature storage area
4. Inner box material: stainless steel plate (SUS 304#)
5. Outer box material: steel plate baking paint
6. Insulation material: high temperature tank: 24k glass wool
Low temperature tank: PU foam + glass wool
7. Heater: bare wire type electric heater
8. Air supply circulation system    
a.TECO motor
b.Stainless steel elongated shaft
c.Multi-wing fan (SIROCCO FAN)
9. Door: single piece door, 1 type of high temperature tank and 1 type of low temperature tank
a. Flat recessed handle
b.Back knob: SUS 304#
c.Silicone foam strip
10. Test hole: 1 x ψ50mm hole in the body, 1 x silicone plug head.
11. Test material placement shelf: stainless steel SUS 304# 2 pieces of shelf tray.
12. Mobile castors: including mobile castors (with foot cup).
13. Drive: cylinder drive.
14. Tightening: silicone foam tightening.